Micro / Mini Helicopter Pitch Gauge with 11 degrees of range
By E-flight for any Micro Heli
This micro pitch gauge is perfect for any micro helicopter such as the T-Rex, Blade CP and others. It has 11 degrease of both positive and negative pitch ranges enough to satisfy the most extreme 3D pilot. The handle is made of nice silicone material so its easy to get accurate readings.
- Silicon rubber - 11 degease - For any micro heli
Trex Superior Edition ( SE ) Main Frame side frames
Metal Tail Holder Set (Gray) (AGNH1242G)
Metal Flybar Seesaw Holder Gray
Metal Control Lever
T-Rex CNC Metal Tail Boom Brace ( Blue )
For all versions of the T-Rex
450V2 Fiberglass Canopy White
Perfect airbrush canvas!
Upper Four Arm Swashplate Replacement
Metal Washout Base
T-Rex Metal T-type Control Lever
Anodized blue
The push / pull metal T-Type control levers come pre installed with bearings and machined with precision ball link balls. The push / pull levers allow for maximum torque while reducing servo strain. The parts are from align and designed specifically for the T-Rex. Blue anodized to match existing blue align parts. Hardware is also included in kit.
- One pair per kit
- Blue colored
- Direct replacement
T-Rex Tail Drive Gear Assembly
Anti Rotation Bracket
Mixing Arm Set with Slide Bearing
450XL Upgrade Refitting Components with Alloy boom and CF boom
Flybar Control Set XL
CCPM Rifitting Components
* Convert your HDE Bell Hiller into a CDE eCCPM Kit
Landing Skid (White)
Carbon Fiber Replacement Frames
Metal Tail Rotor Set
Metal Main Rotor Holder ( Blue )
Anodized blue
All aluminum CNC blade grips will produce a stiff rotor disk which is most noticeable when flying inverted and when putting series load on the rotor head. Any 3D flyer should install these amazing grips and they produce amazing results.
- Kit Includes: Everything which shown in picture - Install in minutes and it is a direct replacement - Super CNC part which is recommended by the manufacture - Blue anodized to match series of other blue anodized Trex parts
Metal Rotor Housing with slider ( Blue )
select checkbox below:
Metal Rotor Housing with slider ( Blue ) 36.99 Metal Rotor Housing - no washout ( Gray ) 30.99 Metal Washout Base only ( Blue ) 7.49 Metal Washout Base only (Gray) 7.40
Control Lever Set(XL)
9.03
PART#HS1085
CCPM Swashplate(XL)
12.18
PART#HS1090
CCPM Rifitting Components with swashplate
21.00
PART#HS1092
* Convert your HDE Bell Hiller into a CDE eCCPM Kit