This compact 11.5 V to 15V DC 2 cell Lithium charger / balancer outputs 0.5A and ideal for small battery packs. Designed by E-Flight for the Blade CP and other Micro Helis which use 2 cell Li Packs. Also available separately is a 120V converter so you may connect balancer / charger directly into a wall outlet. The Charger / Balancer comes with a hook up to the 120V AC/DC convertor so it is very easy to install.

A very economical six channel transmitter with CCPM mixing. The TX uses Futaba dual negative shift and comes with equipped with on / off 3D mixing switch and all channel reverse mode capability. This convenient inexpensive transmitter can practically fly any Fixed Pitch or Collective Pitch R/C Heli such as the Zoom / Shogun / ECO-8 / 16 Hummingbird Pro Viper CPX and others. Of course this transmitter does not have all of the bells and whistles that other higher end transmitters have but for this economical price you simply can’t beat it. This is an all in one practical beginner’s choice radio. Available from two distributors ( same product with different packaging ) including E-Flight and E-Sky.

The Vertical Tail Fin is machined from Carbon Fiber material, very light, strong and stylish. It is designed to protect tail rotor and tail motor during landing. Vertical Tail Fin is made with 1.50mm thickness Carbon Fiber sheet to minimize Tail Fin vibration. Used to replace the stock vertical rod on EFLITE Blade CP/CP2 and Honey Bee CP2 helicopters.

This is an ideal powerhouse motor for anyone using a Micro Heli with a brushed motor who does not want the hassle and expanse of migrating to a brushless motor. This awesome upgrade is a quick swap with your existing 300 - 370 brushed canned motor. Use the same wiring and same connector. Simply hook up the + and - and move the pinion over and you are done. And talk about power, coupled with a Lithium pack this motor will make your Heli go ballistic. This is a powerful 42,000 RPM, 21 Turns full ball bearing raced motor. Just what the Doctor ordered, for your Heli that is.

Modify your Honeybee or Blade CP with this high quality all aluminum CNC Swashplate and you will be amazed by the precision and stability gained. The part is blue anodized with a center brass ball. The center brass ball insured a super smooth cyclic control. Anti rotation pin is a metal rod which will sustain under most crashes. Precision ball ends come pre installed !!!

This E-Flight ultra light 7.4V is made for Micro Helis such as the Blade CP E-Sky Honeybee and others. It comes with a balancing lead (see EFLC3100) which makes it an ideal pack. The 800mAh is lower capacity thus its very light and slim which insures long flight time and ultra responsiveness from your favorite Helicopter.

This 3-in-1 Control Unit, Mixer/ESC/Gyro was designed for the Blade CP Pro version as it is very reliable and engineered to be used with a 3 Cell Lithium Pack. The Gyro has both Gain and sensitivity control. Comes pre wired with standard JST and Futaba plugs for easy installation on your Helicopter.

This inexpensive 6 Channel receiver was designed for Micro Helis such as the Blade CP and CP Pro. RX comes without a crystal. Antenna wire can be left hanging or replace long antenna with Micro Antenna such as the Deans antenna for better results.