 |
|
|
|
|
SONIX-18A Brushless ESC
|
|
|
|
|
|
For all 400 and 500 size helicopters
|
|
|
|
The Sonix 18 amp brushless speed controller features Extreme low resistance, super current endurance. Low-voltage cutoff protection - This prevents discharge problems and increases the life of your lipo packs, over-heat protection, throttle signal loss protection. Smooth and accurate speed control, excellent throttle linearity. |
|
|
|
- 3 startup modes: normal/soft/super-soft
- configurable throttle range
- microprocessor uses separate voltage regulator ic with excellent anti-jamming capability
- supported highest motor speed: 210000 RPM (2 poles), 70000 RPM (6 poles), 35000 RPM (12 poles)
- Cont current:18A / Burst curr: 22A
- BEC mode: linear / BEC output: 5V/2A
- Weight: 19g / Size: 45x24x11mm
|
|
|
|
|
|
|
|
|
|
|
|
SONIX-30A Brushless ESC
|
|
|
|
|
|
For all Brushless Motors. Great for 400 size Helis
|
|
|
|
The Sonix 30 amp brushless speed controller features Extreme low resistance, super current endurance. Low-voltage cutoff protection - This prevents discharge problems and increases the life of your lipo packs, over-heat protection, throttle signal loss protection. Smooth and accurate speed control, excellent throttle linearity. |
|
|
|
- 3 startup modes: normal/soft/super-soft
- configurable throttle range
- microprocessor uses separate voltage regulator ic with excellent anti-jamming capability
- supported highest motor speed: 210000 RPM (2 poles), 70000 RPM (6 poles), 35000 RPM (12 poles)
- 3A voltage regulator + anti-glitch ferrite ring
|
|
|
|
|
|
|
|
|
|
|
|
Mixeron Sub Micro Heli 3-in-1 Mixerboard
|
|
|
|
|
|
Used in ultra light and brush motor powered helicopters.
|
|
|
|
The 3 in 1 Mixeron MixerBoard integrates the single rate Gyro, Revo mixing and the two ESCs of main and tail motors on Sub Micro Helis such as the HeliStar, Precision MicroHeli FP / CP and others. Through this board you can easily adjust the Gyro's sensitivity, mixing rate and rudder stick revolution rate. Also it provides low voltage indicator and lowest voltage auto shutdown mechanism. Works with both 2 and 3 Cell lithium packs. |
|
|
|
- Pre wired with Micro connectors
- Very reliable
- Works with Lithium packs
- Ultra light and small for Sub Micro Helis
- Main ESC output max: 5A
- Tail ESC output max: 3A
- 3 Cell Low volt Indicator: 10V
- 2 Cell Low volt Indicator: 7V
- 3 Cell Low volt Auto Shutdown: 9V
- 2 Cell Low volt Auto Shutdown: 6V
- 5V BEC Max: Current 1A
- Weight: 7g
- Size: 20mm x 25mm x 10mm
|
|
|
|
|
|
|
|
|
|
|
|
Sub Micro Heli 2-in-1 ESC
|
|
|
|
|
|
For Palm Size Sub Micro Helicopters
|
|
|
|
These Speed controlled designed for use in Helis operating with brushed motors. It features a soft start which enables this speed controller to be suitable for R/C Helis. Includes MCU decoder with fine resolution with 1024 steps. Also includes BEC, Safe power on, soft start, auto cut and much more. Size is only: 18mm x 12mm x 6mm. Control two motors and comes with Micro white connectors as well as JST battery connector. Perfect for Dexterity, HeliStar and others. |
|
|
|
- Size: 18mm x 12mm x 6mm
- Weight: 6.6g
- Auto cutoff: 4.2V Ni-MH 5-8 Cells
- Current: 3A
|
|
|
|
|
|
|
|
|
|
|
|
Thunderbird-54 Brushless Speed Controller
|
|
|
|
|
|
By Castle Creations
|
|
| | |
