HeliHobby.com is your source for Remote Control RC Helicopters, products, modifications and more. Full Range of Nitro, Electric and Micro Helis in stock.
Aluminum blade grips for Logo 10 with lower thread
For Logo 10
The logo 10 is a marvelous machine but it was not designed to be used with lithium high capacity battery packs. Powered by Lithium the Logo 10 becomes ballistic with extremely high RPM rotor disk and enormous power. These blades were designed to replace the plastic stock blade grips
and so they Logo 10 can now handle the extreme rotor disk with the fear of a blade grip detaching or loosening due to flex during flight. If you fly with CG or GF main rotor blades these blade grips are a must. The blade grips also have a built in lower thread and so this is a cleaner installation over stock part.
54.99
PART#IP6154
Designed to withstand very high loads
No need for nut to hold main rotor blades
Anodized blue
Direct replacement of stock part
Machined from a single block for ultimate strength and rigidity
Logo 20 To Logo 24 Conversion Kit
Complete conversion
Upgrade your large Logo 20 to the largest most powerful Bionic 24. This kit comes with everything you need for the job including CF frames, lots of hardware and of course a conversion manual. Just what you expect from Mikado.
