After market Raptor 60 3D Vertical and Horizontal Fin set. The fins are similar to the ones produced by Thunder Tiger but these fins are very rigid and produce stronger support for the vertical tail.
- Pre drilled mounting holes
- By MJP Carbon
- For the Raptor 60
Carbon Fiber 3D Paddles for 50 size Helis
With flybar set screw mounts
These Carbon Fiber 3D composite paddles were designed for 50 size R/C Helicopter such as the Raptor 50. Equipped with a 3mm flybar mount the paddles are held strong in place using the supplied set screws. Remember to use red Loctite for secure installation.
- Solid Composite
- Size: 80x50mm
- Fully Airfoil
CF fins for Raptor 30-50 2mm (horizontal)
For the Thunder Tiger Raptor and equivalent Machines
Inexpensive fin by RJX with pre drilled holes for mounting clamps. Will make your flight more stable and your Heli more attractive with this beautifully finished fin set. Only the best for your Raptor.
- Produced by RJX
- Direct replacement
- Increase stability and control
107mm Carbon Tail Blades
Grey CF Fin (vertical) for 30-50 Raptor 2mm
For the Thunder Tiger Raptor and equivalent Machines
Inexpensive fin by RJX with pre drilled holes for mounting clamps. Will make your flight more stable and your Heli more attractive with this beautifully finished fin set. Only the best for your Raptor.
- Produced by RJX
- Direct replacement
- Increase stability and control
