HeliHobby.com is your source for Remote Control RC Helicopters, products, modifications and more. Full Range of Nitro, Electric and Micro Helis in stock.
CNC Aluminum Metal Quad and Penta-Blade Rotorheads
Choose between 3 and 4 blade setup
CNC Aluminum Metal Quad and Five-Blade Rotorhead For RC Helicopters. Designed to fit the T-rex 450X, T-Rex 450S,T-Rex 450XL CDE,T-Rex 450XL HDE, X-400, MX-400, CX-480, Dragonus II RC helicopters. Includes dual 90 and 120 degree CCPM swashplate / (3) Metal Main Blade Grips / CNC Rotor Hub / CNC Washout Base / CNC Arm Set / Main Shaft.
- Perfect for 400-450 Size Helicopters
- Pre-assembled and ready to be installed
- 3D Capable!!
RRP 16T or 17T Pinions for after market low pitch main gear only
For Helis using the same main gear pitch as the T-Rex
Use these pinions for increased RPM on your T-Rex and other 400 size Micro Helis which use a .5 pitch main gear. These high quality RRP pinions come with a set screw for a solid installation ( use RED Loctite to make sure they do not slip or make a flat area on the Motor's shaft to make sure the installation is secure ).
- Available in 16 and 17 T - .5 Pitch - 3.0mm bore - Only for the Zero-G main gears
Metal Control Lever Combo for Trex 450XL (Blue)
ships with ABEC-5 High Quality bearings for ultimate smoothness
Combo pack includes both mixing levers and washout arms. Better flight control is achieved using these superior flex free parts which come fully raced. Also plastic ball links come pre installed so installation on your Trex 450 is a breeze.
- Kit Includes: Everything which shown in picture - Available in multiple colors - Ball sizes are a direct match with stock Trex ball links
Metal Tail Servo Mount (Blue)
Anodized Blue
The lightest and most convenient way to mount a servo on the Trex 450X R/C Helicopter. The adjustable mount will allow you to mount a servo anywhere on the boom and also any size servo from the smallest FMA sub-micro servos to the larger Futaba Digital Mini Servo. The kit comes complete with hardware and the clamps hook directly onto the boom. Installs in minutes.
- Machined from a single block material for ultimate strength - Includes mounting hardware - Anodized blue
T-Rex CNC Tail Rotor Control Set
A must have upgarde
The T-Rex is the perfect machine. However if you had to find one weak spot it would have to be the stock tail rotor control unit. Sometimes the plastic will crack and break due to the excessive tail rotor speed. This mod fixes that weakness as it is fully CNC and extremely strong and rigid The brass cylinder insures the ultimate bind free tail rudder control and you can always feel confident to pirouette at full speed when this CNC upgrade has been installed. It comes pre assembled so installation is a breeze.
