The Rotopod is a heavy weight 45 degrees ( out of ground effect system ) and comes complete with a strong base plate which connects to all four training rods. Train with your Nitro machine while still on the ground or hop around with security and safety until you are ready to Hover. Two versions of this trainer are available one is a up to 71 lbs ( .30 / .50 size ) while the other if for the largest machines up to 101 lbs ( .60 / 90+ ) so choose the version that's right for you !!!

Protect your machine when setting it up or when learning to fly with these properly sized training gear. The kit will allow you to survive not so perfect landings. The size of these training gear was specifically produced around the dimensions of a typical mini size Heli. It allows for minimum weight gain while still protecting your rotor blades from chipping do to a ground strikes and tip overs. The training gears also feature 30 degrease of carbon rod angle which allow for additional spring like protection from hard landings. Made with indestructible soft balls ( not ping pong balls which easily crumble ). This is a high quality product. Includes all you see in picture ( base has room to support up to six carbon rods ).

Essential for the beginner heli pilot turning any copter into a trainer. The set includes four plastic balls and light carbon rods. The gear attaches to helicopter skids and creates a larger base to promote safe landings making the heli less likely to tip over.

This cable enables you to connect your ECO or Logo to any 12V car battery and practice your hovering skills for as long as you want. From Ikarus.

Protect your machine when setting it up or when learning to fly with these properly sized training gear with spinning ball ends and zip ties. The kit will allow you to survive not so perfect landings and since the size of these training gear was specifically produced around the dimensions of the Zoom / Zap / Shogun machines it allows for minimum weight gain while still protecting your rotor blades from chipping do to a ground strikes and tip overs.

The ultra light plastic training gear will protect your Heli from tipping over yet will not degrade flight performance due to excessive weight. Perfect size for mid size electric Heli such as the Eolo Logo ECO and Voyager E. Large balls and zip ties included in the complete kit.

Protect your investment with these wood training gear. Perfect size for mid size electric Heli such as the Eolo Logo ECO and Voyager E. The wood base allows for a better fit with a stronger more rigid support structure. A bit heavier than the Plastic version. Light plastic balls and mounting hardware included in this complete kit.

It's like low-cost heli insurance while you're learning the basics! Gear attaches to heli skids to create a LARGE base for safer landings - heli is much less likely to tip over. Consists of a center section that holds four heavy-duty wood dowels and four sturdy 4 large plastic balls that act as wheels. Also helps stabilize the model in the air by adding bottom weight that lowers the CG and reduces fuselage swinging.

Gives the beginner the ability to learn to fly an R/C helicopter with a substantially reduced risk of crashing. Beginners can now learn quickly easier safer and cheaper. Fiberglass stick with tuff center hub. .30 - .50 and .60 - 90. sizes are available.