Tail blade grips only, rear half of heli not included

Weighted tail blade grips are proven effective and functional on full sized helicopters and RC helicopters.
The G-Force weighted CNC tail blade grips are a bolt-on upgrade with performance that you can feel.
The weights are used to reduce the momentum of the blades that have a tendency to center themselves. These natural forces put extra load on the tail servo and reduces its response.
The G-Force tail blade grips incorporate weighted flanges closest to the center near the hub and linkage point for best performance. The flange is also pre-tapped so you can add more weight if necessary to fine tune your setup.

The 450 version (Part #GFT6010) will fit both T-Rex 450 V1 and V2. A V2 hub is required.

The benefit of increasing the voltage in your setup is no secret. This power package allows you to run a 6 cell lipo on your Trex 450 or other 450 class helicopter. A 6 cell lipo is much more efficient, increasing power and decreasing heat. We packaged this with quality components including the Castle Creations 50AMP LITE ESC w/Data Logging to power your motor using the built in switching BEC to run your electronics. The Lightning Power 6s 1300mah battery included in this package was specifically designed to fit a 450 class helicopter such as the Trex 450. This setup is extremely powerful but the benefits achieved by a cooler running setup yields interest from every kind of R/C heli pilot.

This package has been updated to use the new Castle Creations Phoenix ICE Lite ESC. The Phoenix ICE has built in data logging and a switching BEC which is more than adequate to power full digital servos/gyro on your 450 class heli.