Hold your servos in place with both style and rigidity eliminat -ing servo flex and play. The kit includes eight plates and each plate comes with the needed hardware to mount the plate. All plates are anodized in a matching purple color.

This CNC high grade tail rotor hub comes is made of hardened steel thus dramatically reducing the chance of slippage or breakage during flight. Tail RPM of the Voyager E is very high and this precision rotor hub improves overall tail control and performance.

The Swashplate leveling tool is machined from aluminum and mounts to the main mast to check if the swashplate is in the correct position therefor allowing an exact linkage connection possible. The magnet is used to allow the swashplate leveling gauge to mount to the main mast very easily and quickly.

Voyager E precision hardened spindle shaft set comes complete with all washers and bearings. Replace the stock spindle with this after market KSJ version which is stiffer and comes with higher quality bearings.

Machined from a solid piece of aluminum for a tight and strong fit.

Metal Swashplate with upper and lower rings CNC machined from hard aluminum. Greatly increases the rigidity and the control precision. A special surface treatment is applied on the metal ball of the Heim bearing.

The Seesaw includes the bearings which are pre-installed. The part is machined from a solid piece of aluminum for a strong tight fit and includes mounting hardware.

CNC machined aluminum blade grips with bolt. The blade grips are stiff and will remove flex and tear which can occur with plastic blade grips. Parts are anodized purple to match complete set. Thrust bearings included in this kit.

The bell crank for the Voyager E electric Helicopter comes with a brass insert which seats snuggly in the pitch slider. This bell crank comes with all high quality ball bearings and it is anodized purple to match the rest of the CNC aluminum parts for the Voyager E.

Pitch lever cylinder and cup with dual ball bearings for the Voyager E CCPM Electric Helicopter. A more precise tail control and a crisp tail setup are just a few of the benefits of this upgrade.

Increase the overall frame rigidity and smoothness of the main shaft with this after market anodized upgrade from KSJ for the Voyager E. The kit comes complete with assembly hardware and will install as a direct replacement to the stock plastic part !!! Available in both dark and light purple color scheme.

CNC machined aluminum tail gear case for JR Voyager E helicopter. 3.5g less weight than the stock tail gear case and more rigid. Completely brings out the power of the electric motor and reduce the vibration from the tail.

Replace the stock paddles on the Voyager E with these after market KSJ 3D dynamic paddles. Lighter and more aerobatic paddles allow for a more responsive cyclic control and also allow for a more crisp and accurate response from the swashplate input.

This CNC tail pitch slider for the Voyager E comes complete with both the brass slider as well as the aluminum center slider. The plastic ball links come pre installed. Remove slop and increase tail precision with this cool purple anodized after market part.

Voyager E CNC machined delring gear with an aluminum center gear. Made by KSJ specificaly as an upgrade to the Voyager E electric R/C Heli.