CNC Drive Shaft Gear will replace the stock plastic gear which gets worn out so often ( even without crashing ). The CNC Gear insures smooth meshing for a very long time. It also includes the center hexagon center so slippage is impossible.

Designed to gain higher tail authority and better gyro holding power by increasing the gear ratio. The conical pinion gear teeth number has been increased from 11T to 14T. These two CNC Tail Bevel Gears are made of special BLUE material. The Bevel Gear set is just better with the BLUE material as well known by many expert Heli pilots. A High Speed Steel Tail Shaft 2x45mm MH-4037HS45 (a 6.5usd value) is included! An Aluminum Precision Shaft Collar MH-040 (a 5.99usd value) is also included ! As well as all hardware! Gears come in pair and installed. A Super deal!

The CNC machined tail gear is a direct replacement to the stock plastic beveled version. It is made of strong aluminum and it will handle the most aggressive flying and even sustain its integrity after a major crash. It meshes perfectly with both the plastic nylon and CNC aluminum gear. For best results install this upgrade with the CNC beveled drive gear and apply a bit of grease / lubricant for a super smooth tail system. The kit also comes pre installed with a precision steel tail drive shaft for a smooth fit onto the tail gear box bearings. Get rid of tail wear with this awesome upgrade. Tested at 30 000 RPM.

Complete aluminum tubing set includes smooth and stiff boom as well as boom support and skids. All come in matching anodized color. Available sets come in black blue and red. The kit will bring your machine to life with a sharp looking anodized matching set.